Datamax Allegro 2 Uživatelský manuál stáhnout pdf (Strana 64)

Creating Labels Using Internal Batch Software

56 Allegro2

Copy Module: Copies graphic images and/or label

formats from one memory module to

another. Be certain that the Write Protect

Switch is ‘on’ for the source module and

‘off’ for the destination module.

Metric: Each time the number 3 is pressed, the

screen will toggle between Metric ‘No’

and Metric ‘Yes’.

Print Test Label: Prints a Printhead Test Label and is used

as a relative gauge of Printhead condition

and wear.

System Test Label: Lists all current Printer settings and

checks both ROM and RAM. Prints a

Printhead Test Label after the system test.

Edit Module Name: This will allow you to change the name of

the module.

Reset Printer: This is the same as the <SOH #>

Command in the standard Printer Mode.

If switch 7 is on than the Internal Batch

will take over.

Exit To RS-232 System: This is the same as turning Switch 7 ‘off’

and resetting the Printer. You can use the

<STX g> command to enter the Internal

Batch without using switch 7 in the rear

of the Printer.

Pack Module Data: All the label formats are stored in a 256K

Flash Module; therefore, only the entire

Module can be cleared. For this reason,

the data will occasionally need to be

packed from time to time when the

memory becomes low.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 114 115

Žádné komentáře

Datamax Allegro 2 Uživatelský manuál Strana 64