Datamax H-4606X Návod k obsluze stáhnout pdf (Strana 122)

112 H-Class

Fault Messages (continued)

Displayed Message Description Possible Solution(s)

HEAD CLEANING FAULT

The scheduled

printhead cleaning has

been exceeded by an

amount equal to three

times the pre-

programmed distance.

Clean the printhead (see

Section 5.6.6).

To change the cleaning setting,

enter ADVANCED MENU /

MEDIA SETTINGS / PRINTHEAD

CLEANING MENU.

OUT OF STOCK

The printer cannot

detect the presence of

media.

Examine the printer for media

then proceed accordingly:

• If the printer is out of

stock, load media; or,

• If stock is loaded, ensure

that the Media Sensor is

calibrated (see Section

3.4), properly positioned

(see Section 3.2) and, if

the media has large gaps,

that the Paper Empty

Distance is adjusted (see

Section 4.2.1).

POSITION FAULT

Possible causes of this

fault include a firmware

update, a power failure

or reset during a ribbon,

out of stock or TOF fault,

and an incomplete

calibration process.

Press the FEED Key in an

attempt to identify and then

clear the fault. Perform

calibration (see Section 3.4).

PRINT ENGINE FAULT

A problem within the

print logic has been

detected.

Cycle printer power OFF and

ON. If the fault does not clear,

call for service.

RAM FAULT

A memory failure has

been detected.

Cycle printer power OFF and

ON. If the fault does not clear,

call for service.

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 185 186

Komentáře k této Příručce

Žádné komentáře

Datamax H-4606X Návod k obsluze Strana 122

Komentáře k této Příručce

Související produkty a manuály pro Tiskárny štítků Datamax H-4606X